Important information + Mask sizing

I’ve been flooded with requests for face masks since the beginning of this pandemic - and we’re finally jumping on board by releasing our first limited run of Face Masks! 


There is some important information that we just want to pop out there before they go live this Thursday night (12th August 2021) at 6pm INCLUDING sizing because due to pretty obvious health reasons - we won’t be able to accept returns on these for change of mind or incorrect sizing. 

To make it easier here is the exact pattern that we’re using so that you can print it off and physically see it against your face (please allow approximately half a centimetre for seam allowance though!):

We’ll be sewing ours using two layers of cotton woven fabric with a layer of interfacing in the middle. The mask elastic length we also use is 6 inches long - If you want to have a go at making one at home though then make sure you cut 7 inches to include enough to sew into the mask. 

If you just want to see the actual measurements though instead of printing them then they are: 

- 4 inches across the bottom

- 4 inches up the smallest side 

- 5 inches at the highest point 

Please allow half a centimetre give or take as masks may very slightly vary due to their handmade nature.

While you’re here though, have another visual: 

We also just need to STRESS that these are NOT medical grade or surgically rated and aren’t recommended to be a replacement for PPE if a surgical or P2 mask is available to you. 

Please continue to social distance and listen to the advice and directives from the Government and Health Officials. 

Eeekkk! Can’t wait to see you matching with your Scrunchies and Earrings like I’ve been! 


Cahlua x

Leave a comment